Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
85
Roller, Cable and Fan Replacement
Replacing the Platen Roller (D900041)
Refer to Drawing D900110.
Tools Needed: Torx T-10 Screwdriver, Retaining Ring Pliers
Parts Needed: Platen Roller D900041, Retaining Ring (X1)
140048, Roller Shaft Locking Bushing D90046, Retaining
Clip 140062 (X1)
Estimated Repair Time: 35 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Remove the Stepper Motor Idler Pulley (D840888) and the Platen Roller Drive
Gear (D900047). See Replacing the Stepper Motor Idler Pulley (D840888) and
the Platen Roller Drive Gear (D900047).
Continued on the next page