Fellowes DS-1 Paper Shredder User Manual


  Open as PDF
of 40
 
ENGLISH
Model DS-1
2
CAPABILITIES
Breakthrough Safety Technology! SafeSense
®
stops shredding when hands are too close to the opening.
Active Not Active
Lift and
remove basket
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, large paper clips, laminates or plastic other than noted above
Paper shred size:
Cross-Cut ............................................................................................. 3.9 x 35mm
Maximum:
Sheets per pass (Cross-Cut) ................................................................................13*
Cards per pass ...................................................................................................... 1
Paper width .................................................................................................230mm
*70g, A4 paper at 220-240v, 2.0Amps; heavier paper, humidity or other
than rated voltage may reduce capacity.
SET UP
—
To Test SafeSense® Technology
Press Auto-On ( ) Touch Test Area Sensor lights up
Shredder comes fully assembled. Remove basket packing material and plug in.
Disconnect Power Switch must be in ON (I) position to operate shredder.
Magnetic
safety interlock
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
15
15
• Keepawayfromchildrenandpets.Keephandsawayfrompaper
entry. Always set to off or unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–away
fromshredderopenings.Ifobjectenterstopopening,switchto
Reverse(R)tobackoutobject.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Donotuseifdamagedordefective.Donotdisassembleshredder.
Do not place near or over heat source or water.
• Operation,maintenance,andservicerequirementsarecoveredin
the instruction manual. Read the entire instruction manual before
operating shredders.
•
This shredder has a Disconnect Power Switch (F) that must be in the ON
(I) position to operate shredder. In case of an emergency move switch to
OFF (O) position. This action will stop shredder immediately.
• Avoidtouchingexposedcuttingbladesundershredderhead.
• Donotputforeignobjectsinpaperentry.
• Shredder must be plugged into a wall outlet or socket of the voltage and
amperage designated on the label. The outlet or socket must be installed
neartheequipmentandeasilyaccessible.Energyconverters,transformers,or
extension cords should not be used with this product.
• FIREHAZARD–DoNOTshredgreetingcardswithsoundchipsorbatteries.
• Forindooruseonly.
KEY
I. Control switch
1. Auto-On
2. OFF
R 3. Reverse
A. SafeSense
®
Technology
(yellow)
B. Paper entry
C. Mesh basket
D. SafeSense
®
override
switch
E.Step
F. Disconnect power switch
G. See safety instructions
below
H.LEDLights
Overheated (red)
Standby (green)
F.
A.
E.
C.
D.
B.
G.
H.
I.
 previous next