Fellowes DS-1 Paper Shredder User Manual


  Open as PDF
of 40
 
Press Auto-On ( )
Set to Off
Set to Off
Feed into paper entry
and release
Set to Off
Set to Off
LimitedWarranty:Fellowes,Inc.(“Fellowes”)warrantsthepartsofthemachinetobefreeofdefectsin
material and workmanship and provides service and support for 1 year from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material
and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
atFellowes’optionandexpense,ofthedefectivepart.Thiswarrantydoesnotapplyincasesofabuse,
mishandling, failure to comply with product usage standards, shredder operation using an improper power
supply(otherthanlistedonthelabel),orunauthorizedrepair.Fellowesreservestherighttochargethe
consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country
wheretheshredderisinitiallysoldbyanauthorizedreseller.ANYIMPLIEDWARRANTY,INCLUDINGTHAT
OFMERCHANTABILITYORFITNESSFORAPARTICULARPURPOSE,ISHEREBYLIMITEDINDURATIONTO
THEAPPROPRIATEWARRANTYPERIODSETFORTHABOVE.InnoeventshallFellowesbeliableforany
consequentialorincidentaldamagesattributabletothisproduct.Thiswarrantygivesyouspecificlegal
rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations,restrictions,orconditionsmayberequiredbylocallaw.Formoredetailsortoobtainservice
under this warranty, please contact us or your dealer.
Continuous operation:
4-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5 minutes will trigger
20-minute cool down period.
Pull uncut paper
from paper entry
Press and hold
Reverse (R)
Set to Off Press and hold
Reverse (R)
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
Shredder doesn’t start:
Alternate slowly back and forth
Press Auto-On ( )
Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.
PAPER
CARD
Holdcreditcard
at edge
Feed into card
entry and release
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switchinordertoperformstepsabove.Oncethejamiscleared,resetthe
SafeSense
®
feature. (See SafeSense
®
instructions below.)
SafeSense
®
override switch
Active Not active
Sensorlightilluminated–paper
jammed
SafeSense
®
paper jam: If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user
tothinktheshredderhasjammedwhenithasnot,usetheOverride Switch to deactivate the SafeSense
®
feature and clear the paper. Warning–whenswitchisinoverrideposition,theSafeSense
®
light will flash and
the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
Yellow-SafeSense
®
active
Yellowflashing-SafeSense
®
not active
Make sure control switch is in Auto-On
( ) position
Clear paper particles covering magnetic
safety interlock
Wait20minutesforredlighttoturnoff
LIMITED PRODUCT WARRANTY
1
2
1
3
1
1
4
1
2
1
3
1
5
1
1
4
1
5
6
2 3 4
15
15
*Apply oil
across entry
Press and hold Reverse
(R) 2-3 seconds
Set to Off
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
1
2
1
3
Allcross-cutshreddersrequireoilforpeak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
 previous next