Filter
Top Products
FS-8700-132 Gamewell FCI-E3 Driver Manual Page 19 of 20
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Appendix B.1. Driver Stats Exposed.
In addition to the standard FieldServer operating statistics the driver exposes certain key stats in a
Data Array if required. An upstream device can then monitor these stats.
Add the following to your configuration file to activate these stats.
// Expose Driver Operating Stats.
Data_Arrays
Data_Array_Name, Data_Format, Data_Array_Length
fci-e3-stats, UINT32, 200
The driver exposes stats based on a port handle. The offset specified in the table below must be
added to the handle number multiplied by 100. i.e. for port whose handle is 1 then the driver will store
the 1
st
stat at 1+100*1=101.
Stat Offset
Description
#define FCI_E3_STAT_NO_PLACE_TO_STORE 1
Increments each time point data is
received but there is no Map
Descriptor to store the data (any)
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_ZONE
2
Increments each time point data is
received but there is no Map
Descriptor to store Zone data
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_RELAY
3
Increments each time point data is
received but there is no Map
Descriptor to store Relay data
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_LOOP
4
Increments each time point data is
received but there is no Map
Descriptor to store the Loop data
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_SENSOR
5
Increments each time point data is
received but there is no Map
Descriptor to store the Sensor
data
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_MODULE
6
Increments each time point data is
received but there is no Map
Descriptor to store the Module
data
#define FCI_E3_STAT_EMPTY_MSG 7
Number of times that a message
line was zero bytes long
(excluding the terminator)
#define FCI_E3_STAT_SHORT_MSG 8
Number of times that a message
line was too short probably a
system id tag line
#define FCI_E3_STAT_NO_RESET 9
Increments each time a reset was
rcvd but no Data Array was reset
#define
FCI_E3_STAT_NO_PLACE_TO_STORE_PANEL
10
Increments each time point data is
received but there is no Map
Descriptor to store data that
cannot be attributed to a zone,
relay, loop, sensor, module
#define FCI_E3_STAT_RCVD_MSGS 11
Increments each time a message
is received