Filter
Top Products
26
Model X-34 Owner’s Manual
In this example, a microphone is plugged into the MIC
IN jack 2/4 and a vocal is recorded to track 4.
1. Connect the microphone to one of the MIC
IN jacks 2/4 (1/4” or XLR) on the rear panel of
the X-34.
2. Connect the input/output of the compressor/
limiter to the insert jack 4 as shown in the
drawing.
3. Press the REC TRK switch on channel 4 once
to select track 4 as the recording track.
4. While talking into the microphone, adjust the
recording level using the Trim 2/4 knob until
segments 0 - 3 on the level meter light up.
5. Adjust the effect signal on the compressor/
limiter.
Refer to the manual for the compressor/limiter for
detailed effect settings.
6. Follow the instructions on page 16 for
overdubbing.
In this way, you can apply the compressor/limiter
to only the vocal recorded to track 4.
Applying a compressor/limiter to the mic input during overdubbing!
Using the X-34 insert (LINE IN/INSERT) jack on the front panel, you can apply a compressor/limiter to the mic
sound (vocal) input to the rear panel MIC IN jack (1/4”or XLR).
The INSERT jack accepts a TRS (tip, ring, sleeve) 1/4" connector for bi-directional connection. The tip sends out
the X-34 signal to the effects unit, and the ring inputs the processed signal from the effects unit to the X-34. This
connection requires a special insert cable as shown in the figure below.
000
LINE OUT
RL
MONITOR OUT
RL
AUX RTN
RL/MONO
AUX SEND
2/41/3
MIC IN
TRIM 2/4TRIM 1/3
RESET
–
+
WIDE PITCH
4321
RL
FIX
NORMAL
POWERRECNR
-
+
10
5
0
3
6
-
10
5
0
3
+
6
PAUSESTOPFFREC PLAY REW
X-34
multitracker
DOLBY B NR
100
100
MONITOR
AUX RTN
MON MIX
AUX
+-
0
+-
0
RL
100
+-
0
+-
0
RL
100
+-
0
+-
0
RL
100
+-
0
+-
0
RL
100
AUX
EQ HI
EQ LO
MON MIX/
PAN
1
2
3
4
1
2
3
4
1
2
3
4
REC TRKREC TRKREC TRK
432
REC TRK
1
2
3
4
1
LINE IN/INSERT
1 2 3 4 MASTER
Down
Track
Bounce
Auto
Microphone
MIC IN 2/4
LINE IN/INSERT 4
Compressor/limiter
Tip (Return)
Ring (Send)