Filter
Top Products
freeView Power 80 User Manual
11
Figure 11 – Network Selection
Network Selection
By default, the software will automatically select a network interface card to use (wired or
wireless). To change the network interface to use, click “Network Selection” to display a list of
available network interfaces (Figure 11), and select the one to use. All devices must be on the
same network as the computer in order to be detected by the software.
Configure
The “Configure” button allows you to configure a freeView Power 80 unit selected from the list
on the right side of the window. The first tab to be displayed is the “IP Address” tab (Figure 12).
On this tab, you can set the IP address of the device dynamically using DHCP, given through
BOOTP, or statically by manually entering the information in the window.
Figure 12 – IP Address Tab
After setting the IP address of the device, you can access the web interface or telnet interface of
the unit from any computer on the same network as the device.
The second tab is the “Advanced” tab (Figure 13). This tab allows you to set a password for
accessing the freeView Power 80 device from the SNMPIV software (this does not affect the