Filter
Top Products
Build the Platform
Build a Demo Platform: Assemble Two Boards
21
i.MX31 PDK 1.4 Quick Start Guide
3. Connect the regulated 5V power supply to the appropriate power adapter. Plug the
power adapter into an electrical outlet and the 5V line connector into the J2 (5V
POWER JACK) connector on the Debug board. See Figure 3-5.
4. Start a serial console application on your host PC with the following configuration
5. On the Debug board, switch the power switch (S4) to 1.
6. The OS image pre-loaded in the 3-Stack board will boot and the debug messages from
the bootloader should now appear on the serial console application on your PC.
Build a Demo Platform: Assemble Two
Boards
This section explains how to make a demonstration platform using the Personality and
CPU boards.
To make a demonstration platform, the CPU board is directly connected to the Personality
board using the 500-pin connector; the Debug board is not used.
NOTE If your system is already configured as a development platform (using all three
boards), disconnect all boards from each other.
Table 3.2 Serial Console Configuration
Baud Rate 115200
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
3StackQS_WinCE.book Page 21 Sunday, September 28, 2008 1:58 PM