Fi-4110CU Image Scanner Operator’s Guide
FOR SAFE OPERATION
Treatment of This Manual
Since this manual contains important information for using the fi-4110CU, read it thoroughly before
using the product. Use the fi-4110CU only after thoroughly reading and understanding especially the
section "Important Alert Messages" in this manual. Keep this manual handy, and store it carefully.
Notice to
American Users
Federal Communications Commission
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Adjust or relocate the receiving antenna.
· Increase the distance between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from the
circuit the receiver is connected to.
· Consult your dealer or an experienced radio/TV technician for help.
FCC warning:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
the equipment.
Notes
·
The use of a non-shielded interface cable with the referenced device is
prohibited. The length of the parallel interface cable must be 3 meters
(10 feet) or less. The length of the serial interface cable must be 15
meters (50 feet) or less.
· The length of the power cord must be 3 meters (10 feet) or less.