Filter
Top Products
3-6 fi-4110CU Image Scanner Operator’s Guide
5) Adjust the document guides to the document width, then straighten the documents.
If the documents are placed loosely between the left and right guides, they may be
read diagonally.
6) Switch the reading mode by pressing the Duplex button.
This switching is available from a screen of the device driver. For details, refer to
the device driver manual.
When the Function No. display is ON, the single-sided reading mode is active.
When the Function No. display blinks, the double-sided reading mode is active.
7) Press the scan button on the main unit.
u
Key point
Press the scan button to start the application software. The
mark is displayed
until the application starts.
If the application software does not start and the Function No. display panel
displays the Function No. again, the scan processing is canceled.
8) After finishing reading, remove the documents from the stacker.
Document guide
Function No. display panel
Duplex button
Scan button
Stacker
u
Note
When validating the Duplex button and Scan button on the equipment using the
TWAIN driver, you must select "Follow Instructions on the Operator Panel of the
Equipment" on the operation environment setting screen of the device driver.