Filter
Top Products
D2530 (Econel 200 S2) Technical Manual 23
Features Connectors and jumpers
LAN connector
On this system board you will find a LAN controller integrated in the Intel
®
6321
I/O controller Hub (ICH). This controller is supported by an external chip (Intel
®
Single 1 GB PHY 82564EB), which is connected to the I/O controller Hub via an
original Intel interface (Kumeran Interface). The LAN controller supports the
transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s and supports WOL function
through Magic Packet™.
It is also possible to boot a device without its own boot hard disk via LAN. Here
Intel PXE is supported.
The LAN controller connector is equipped with two LEDs (light emitting diode)
indicating the transfer rate and the activity.
Figure 6: LAN connector
1 LAN link/activity green on LAN connection
off no LAN connection
flashing LAN transfer
2 LAN transfer rate green + orange off transfer rate 10 Mbit/s (or no
connection)
green on transfer rate 100 Mbit/s
orange on transfer rate 1000 Mbit/s
1 2