Filter
Top Products
fi-5110C Image Scanner Getting Started 2
1.3 Operator Panel
The operator panel is located on the right side of the
scanner. This panel is comprised of a Function Number
display, four buttons and a LED.
■ Indications on the Function
Number display
■ 8
Blinks only one time upon turning on the scan-
ner.
■ P
Indicates that the scanner has been turned ON
and is being initialized.
■ 0
Indicates that initialization will soon end.
■ 1
Indicates that initialization has ended success-
fully.
The scanner is now in "Ready Status".
■ U
Indicates that a temporary error occurred when
documents were being scanned. A number
appearing in alternation following the U (i.e.,
1, 2 and 4) refers to the type of error.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
■ E
Indicates that a device (hardware) alarm has
occurred during scanning of documents.
"E" and the alarm Number (2 to 9 and c) will
appear alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and on
again. If the alarm continues after turning the
power on again, contact your service engineer.
Name Function
Function Number
display
Indicates the function
Number and error status.
Button Function Changes the Function acti-
vated by the Send to button
(*).
Send to Launches the linked appli-
cation software (*).
Scan
Power
button
Turns the scanner ON and
OFF.
LED - Lights when the scanner is
turned ON.
*)
About the settings on the launcher, refer to
FUJITSU TWAIN32 scanner driver help and the
"fi-5110C Operator’s Guide" in the Setup CD-
ROM.
LED
Power button
Scan
Send to
Function
Function No
display