Filter
Top Products
15
Scan Test (Wireless LAN Connection)
Check that the image scanned by the ScanSnap is sent to the computer or mobile device.
1. Disconnect the USB cable connecting the ScanSnap to the computer.
D The ScanSnap is connected to a computer via wireless LAN, and the ScanSnap Manager icon
changes to ( )/ ( ).
2. Scan a document with the ScanSnap.
For details, refer to "Scan Test (USB Connection)" (page 11).
1. Start ScanSnap Connect Application on the mobile device to connect to the ScanSnap.
For details, refer to the ScanSnap Connect Application User's Guide.
2. Scan a document with the ScanSnap.
For details, refer to "Scan Test (USB Connection)" (page 11).
D The scanned image is displayed on the mobile device when the scanning is complete.
If the scanned image is displayed on the mobile device, then the scanning check is complete.
ATTENTION
If the ScanSnap Wireless Setup Tool or the Wireless Network Setup Wizard is running, exit them.
When You Connect a Computer to the ScanSnap
ATTENTION
If the ScanSnap Manager icon is ( )/ ( ), exit ScanSnap Connect Application on
the mobile device.
When You Connect a Mobile Device to the ScanSnap
ATTENTION
zDepending on the ScanSnap installation location, it may take some time until the scanned image is
displayed on the mobile device. For details, refer to "Troubleshooting" in the ScanSnap Manager Help.
zIf the scanned image is not displayed on the mobile device after the scanning is complete, refer to the
ScanSnap Connect Application User's Guide.