Filter
Top Products
9
Connecting the ScanSnap
1. Connect the AC cable to the AC adapter
(collectively called the "power cable").
2. Plug the power cable into the power
connector at the back of the ScanSnap, and
the other end to an AC outlet.
3. Remove the tape seal on the USB connector
of the ScanSnap.
4. Connect the USB cable to the USB connector
on the ScanSnap and the USB port on your
computer.
ATTENTION
zOnly one ScanSnap can be used by a computer at a time.
zUse only the cable supplied with the ScanSnap.
CAUTION
Do not use AC adapters other than the one supplied with this ScanSnap. Doing so may
cause damage to the ScanSnap.
ATTENTION
zWhen connecting to USB hub, make sure to
connect the ScanSnap to the USB hub which is
connected to a USB port of your computer. Use a
powered USB hub (with AC adapter).
zIf USB port or USB hub is USB 1.1, scanning speed
will slow down.
zConnect the USB cable with the USB mark facing
up.
AC Adapter
AC Cable
AC Outlet
Power Cable
Power Connector
Tape Seal
USB Cable