Filter
Top Products
15-10 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
7. Ensure that the metallic underside of the wrist strap is in direct contact with your
skin.
The wrist strap should be snug around the wrist so that it does not rotate. (See Section 1.4,
“Antistatic Precautions” on page 1-9)
Caution – Before handling FRUs, be sure to connect the clip of the antistatic wrist strap
and of the antistatic mat to the server grounding port, and attach the band of the wrist strap
to one of your wrists. Place the FRUs on the grounded antistatic mat. Failure to take these
antistatic measures might result in serious damage.
8. Remove the tape drive unit to be replaced. (See
FIGURE 15-4 or FIGURE 15-5)
a. Using a Phillips screwdriver, loosen the two knob screws securing the tape drive
unit.
b. While grasping the knob screws, pull out the tape drive unit slowly from the slot.
9. Place the removed tape drive unit on an antistatic mat.
10. Mount the replacement tape drive unit by following the removal instructions in
Step 8 in reverse order.
Caution – Do not forcibly push the tape drive unit when inserting it, even if it is not
moving smoothly. You may fail to insert the tape drive unit due to the presence of any
obstruction in a slot or any problem with a connector pin; and if you forcibly insert it, serious
damage may result.
11. Attach the tape drive unit to the port.
Execute the cfgdevice -c attach -p <port no.> command of XSCF.
12. Confirm that the replacement tape drive unit is configured to the domain.
From XSCF, execute the cfgdevice -l command to confirm that the specified port
number is displayed in the current connection.
13. Turn on the power to the relevant domain.
From a console that is connected to XSCF, execute the poweron -d command of
XSCF.
For details of the power-on operation, see Section 4.4.2, “Powering the Server On” on
page 4-22, and the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
User’s Guide.
14. Start up domains as necessary.
15. Close the door on the server and lock it.