Filter
Top Products
3-4 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
FIGURE 3-1 Removing Air Filters (Example for the M8000)
3. Pull out all of the air filters.
4. Use a cleaner to remove dust from the air filters. Attach a brush to the tip of the
cleaner, and clean both sides of the filters.
5. Restore each air filter to its original location and orientation, which means the knob
is on the side closest to you and the arrow on the label points up (the latticework
faces upward).
6. When this restoring work is completed for all the air filters, turn the fixing brackets
of the air filters until they face upward, and then tighten the screws firmly with the
Phillips screwdriver. Finally, close the front and rear doors of the server.
Fixing bracket (x3)