Filter
Top Products
13-6 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
8. Ensure that the metallic underside of the wrist strap is in direct contact with your
skin.
The wrist strap should be snug around the wrist so that it does not rotate. (See Section 1.4,
“Antistatic Precautions” on page 1-9)
Caution – Before handling FRUs, be sure to connect the clip of the antistatic wrist strap
and of the antistatic mat to the server grounding port, and attach the band of the wrist strap
to one of your wrists. Place the FRUs on the grounded antistatic mat. Failure to take these
antistatic measures might result in serious damage.
9. Remove the PCI cassette of the PCI card to be replaced.
Caution – To disconnect the link cable, which is a cable connected between the link card
mounted on the server and external I/O expansion unit, pull the latch lock of the connector.
If you forcibly pull the connector or the cable, the cable may be damaged.
Caution – When removing cables such as LAN cable, if your finger can't reach the latch
lock of the connector, press the latch with a flathead screwdriver to remove the cable.
Forcing your finger into the clearance can cause damage to the PCI card.
a. Using a Phillips screwdriver, loosen the green screw securing the lever.
b. While grasping the upper part of the PCI cassette, pull the lever until it is
stopped, and continue pulling it to pull out the PCI cassette.