Filter
Top Products
13-24 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
10. Mount the replacement PCI card on the PCI cassette. (Perform the work on the
antistatic mat.) (See
FIGURE 13-6 and TABLE 13-2)
a. Move the PCI card in the direction of the arrow, and mount it on the PCI cassette
by inserting the part projecting out at the bottom of the bracket of the PCI card
into the hole at the bottom of the front panel of the PCI cassette and inserting the
pin of the PCI cassette into the notched part at the top of the bracket of the PCI
card. (See
FIGURE 13-7)
b. Push the PCI card until the notched part on the base plate of the PCI card
touches the part projecting from the PCI cassette.
Note – When affixing the PCI card after aligning its position with the card-positioning tab,
do so while pulling the lever about 2 cm from the frame.
c. Align the PCI card with the center part of the lower latch of the cassette. Then,
while pressing the PCI card against the center part of each of the upper latches of
the cassette, tighten the fixing screws in the sequence shown in
FIGURE 13-8 to fix
the card in position.
Note – To ensure that the PCI card is properly mounted, you need to confirm that the PCI
card base is properly centered at the latches and securely fastened in position.
Caution – If the card is short, move the screw at the bottom of the cassette as required. In
such cases, place the latch as close as possible to the far end of the card. See
FIGURE 13-9.
To shift the location of the bottom screw for the PCI card, first secure the card at the lower
latch (part a in
FIGURE 13-8). Then, tighten the fixing screws in the sequence of 1-2 shown in
FIGURE 13-8 to fix the card in position.
11. Mount the PCI cassette.
a. Pull the lever of the PCI cassette until the PCI cassette is pulled out completely
b. Align the PCI cassette with the groove of the PCI slot, and insert the PCI cassette.
c. Press the upper part of the cassette until the cassette is inserted in the same
position as the other cassettes.
d. Push in the lever.
e. Using a Phillips screwdriver, tighten the green screw.
Be sure to stop tightening the screw when the bottom of the screw head is flush with
the projecting part of the handle. Otherwise, over tightening the screw may cause the
projecting part of the handle to break. (See
FIGURE 13-10)