Filter
Top Products
Chapter 6 Replacement of CPU/Memory Board Unit (CMU), CPU Module, and DIMM 6-15
18. Configure the CMU into the system.
Active replacement:
Use the addboard command to dynamically configure the relevant CMU into a domain.
Perform this operation for all the domains that have been recognized in Step 2 as
including the CMU to be replaced.
For details, see Section 4.2.2, “Disconnecting and Replacing a FRU” on page 4-6, and the
SPARC Enterprise M4000/M5000/M8000/M9000 Servers Dynamic Reconfiguration (DR)
User’s Guide.
Hot replacement:
From the console that is connected to XSCF, execute the poweron -d command of
XSCF to turn on power to the domain.
When the power to the domain is turned on, version synchronization of OpenBoot PROM
(OBP) is automatically performed. When version synchronization is completed, the
power-on self test (POST) is performed. When ok prompt displayed on the console of
relevant domain, POST is completed.
19. Confirm that the replacement components are normal by using the showhardconf
or showstatus command of XSCF.
Unless "*" is displayed for a replacement CMU, CPU module, or DIMM, it is operating
normally.
For details of the showhardconf command and showstatus command, see the
SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s Guide, the
SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF Reference
Manual, or the man page.
Note – The showstatus command displays information on degraded components.
20. Close the door on the server, and lock it.