Filter
Top Products
IN-2 C141-E166
E
E-1D-00...........................................................7-4
each mode setting............................................5-8
ECC.................................................................3-8
environmental specification ............................2-4
environmental temperature..............................4-6
environmental/power requirement ..................2-4
error analysis...................................................7-1
error analysis information collection...............7-1
error information indicated with sense data ....7-3
error rate..........................................................2-5
error recovery..................................................1-4
error recovery during self-diagnostic..............6-3
error recovery parameter...............................5-20
external dimension ..........................................4-1
external magnetic field....................................4-7
external operator panel circuit example ........4-21
external operator panel connector .................4-15
F
factory maintenance (parts replacement) ........6-8
field maintenance (disk drive replacement) ....6-8
finding possibly faulty part ...........................6-16
format capacity................................................3-9
format of extended sense data.........................7-2
format parameter...........................................5-18
FORMAT UNIT command...........................5-18
formatting......................................................5-17
G
gaps .................................................................3-8
general description ..........................................1-1
general note.....................................................5-1
H
hardware function test.....................................6-2
hardware structure...........................................1-6
head.................................................................1-7
high speed data transfer...................................1-2
high speed positioning.....................................1-4
I
indicating revision number............................6-10
indicating revision number
at factory shipment ....................................6-9
initial seek operation check...........................6-12
initial self-diagnostic.......................................6-2
installation.......................................................5-1
installation requirement...................................4-1
installation/removal/replacement ....................5-2
interface (SCSI bus) test..................................6-5
internal test space ............................................3-4
L
large capacity ..................................................1-5
leak magnetic flux...........................................4-7
limitation of bottom-mounting........................4-5
limitation of side-mounting.............................4-5
logical data block addressing ..........................3-9
low noise and low vibration ............................1-5
low power consumption ..................................1-5
M
maintenance level............................................6-8
maintenance requirement ................................6-6
mean time between failure (MTBF)................2-5
mean time to repair (MTTR)...........................2-6
microcode downloading..................................1-5
MODE SELECT/MODE SELECT EXTENDED
command .................................................5-17
mode setting ..................................................5-10
motor start mode .............................................5-8
motor start mode setting..................................5-8
mounting .........................................................4-4
mounting drive ..............................................5-11
mounting frame structure ........................ 4-4, 4-5
mounting procedure ......................................5-11
mounting requirement .....................................4-1
N
NC connector location...................................4-11
NC external dimension....................................4-2
NC model drive outer view.............................1-6
note on handling drive.....................................5-1
note on mounting.............................................4-4
NP connector and terminal location..............4-13
NP external dimensions...................................4-3
NP model drive outer view..............................1-6
O
online self-diagnostic ......................................6-3
operation check .............................................6-12
operation test.................................................6-12
outline of troubleshooting procedure ............6-13
output signal for external LED......................4-18
P
packaging ........................................................5-2
PAD.................................................................3-8
page code = 1 ................................................5-20
page code = 2 ................................................5-21
page code = 7 ................................................5-20