Filter
Top Products
Index
C141-E163 IN-
3
reserve and release function ........................... 1-3
revision label .................................................. 6-9
revision number.............................................. 6-9
S
sector format................................................... 3-7
seek test .......................................................... 6-2
self-diagnostic................................................. 6-1
SEND DIAGNOSTIC command.................... 6-3
sense data........................................................ 7-1
sense data analysis.......................................... 7-3
sense key, sense code, and subsense code...... 7-1
sequential starting of spindle motor................ 4-7
service clearance area..................................... 4-6
service life ...............................................2-6, 6-6
service system and repair................................ 6-7
setting parameter .......................................... 5-12
spare area in cell............................................. 3-5
spare disk drive............................................. 5-16
specification.................................................... 2-1
spindle motor.................................................. 1-6
standard feature .............................................. 1-2
start/stop of spindle motor.............................. 1-4
START/STOP UNIT command ..................... 5-6
storage ............................................................ 5-2
surface temperature check point..................... 4-5
surface temperature measurement point......... 4-5
sync mark ....................................................... 3-8
system configuration ...................................... 1-7
system space................................................... 3-4
system-level field troubleshooting................ 6-14
T
take following action if problem occur........... 5-6
test ................................................................ 6-10
test flowchart ................................................ 6-11
test program.................................................... 6-4
tool and test equipment................................. 6-10
track format ....................................................3-5
track skew and head skew............................... 3-6
track skew/head skew ..................................... 3-7
troubleshooting at repair site ........................6-15
troubleshooting with disk drive
replacement in field................................. 6-13
troubleshooting with part replacement
in factory.................................................6-16
U
unpackaging.................................................... 5-2
unrecoverable error rate.................................. 2-5
user space........................................................ 3-3
V
verify error recovery parameter.................... 5-13
W
write/read test ..........................................6-2, 6-5