Filter
Top Products
C141-E226 IN-1
INDEX
16-bit SCSI ID external input........................4-16
16-bit SCSI interface connector....................4-14
68-pin type LVD 16-bit SCSI ........................B-3
8-bit SCSI/16-bit SCSI....................................1-2
A
AC noise filter...............................................4-11
actuator............................................................1-7
addressing of peripheral device.......................1-9
air circulation (recirculation filter,
breather filter)............................................1-7
allowable input voltage and current ................4-8
alternate area ...................................................3-9
alternate block allocation ..............................3-10
alternate block allocation by REASSIGN
BLOCKS command.................................3-13
alternate block allocation during FORMAT
UNIT command execution ......................3-11
alternate cylinder.............................................3-4
alternate spare area..........................................3-3
automatic alternate block allocation..............3-13
automatic alternate block allocation at write
operation..................................................3-14
automatic alternate block reassignment ..........1-4
B
basic operation test..........................................6-5
BCRC..............................................................3-7
block address of user space.............................3-9
bock descriptor..............................................5-17
C
cache feature....................................................1-3
caching parameter .........................................5-22
changing revision number in field...................6-8
check before mounting..................................5-11
check items at illegal operation.....................5-13
checking at abnormal end..............................5-17
checking procedure .......................................5-14
checking SCSI connection .........5-14, 5-15, 5-16
CN1........................................................B-2, B-3
CN2 setting terminal ......................................A-2
command queuing feature...............................1-4
compactness ....................................................1-2
confirming initial operation...........................5-13
confirming operation after installation and
preparation for use...................................5-13
connecting cable............................................5-12
connection .......................................................5-3
connector signal allocation.............................B-1
continuous block processing ...........................1-3
control mode parameter.................................5-22
controller circuit..............................................1-7
current waveform ............................................4-8
cylinder configuration .....................................3-2
D
data format ......................................................3-1
data space ........................................................3-1
default mode setting (by CHANGE
DEFINITION command).........................5-10
defect list.......................................................3-10
defect management........................................3-10
defective block slipping ..................................1-5
definition of sense data....................................7-3
delivery............................................................5-2
diagnosis..........................................................1-5
diagnostic ........................................................6-1
diagnostic and maintenance ............................6-1
diagnostic test................................................6-11
disconnection/reconnection parameter..........5-21
disk..................................................................1-7
disk drive troubleshooting.............................6-14
disk read error .................................................7-4
dismounting drive..........................................5-23
each mode setting............................................5-8
E
ECC.................................................................3-7
environmental magnetic field..........................4-7
environmental specification ............................2-4
environmental temperature..............................4-6
environmental/power requirement ..................2-4
error analysis...................................................7-1
error analysis information collection...............7-1
error information indicated with sense data ....7-3
error rate..........................................................2-5
error recovery..................................................1-4
error recovery during self-diagnostic..............6-3
error recovery parameter...............................5-20
external dimension ..........................................4-1
external operator panel circuit example ........4-21
external operator panel connector .................4-15