Filter
Top Products
Important Alert Items
vi C156-E227-01EN
Task Alert message Page
Assembly and Installation
Device damage: Before moving the drive, remove any optical
disk cartridge in it. If the drive is moved with the optical disk
cartridge loaded in it, the head may move back and forth in the
drive to damage the head or disk, consequently disabling data from
being read later.
Device damage: Do not connect or disconnect any cable except
the USB I/F cable while the drive power is on.
Device damage: Before demounting the optical disk drive, turn
off the system power. While the power is on, do not remove screws
securing the cables and drive.
3-17
3-22
3-23
Cleaning cartridge
Device Damage: Be sure to use the dedicated head cleaner
shown above.
Disk damage: To clean a disk, use the cleaning solution and
cleaning cloth specified in Table 5.2.
Disk damage: Do not use this cleaning kit on a floppy disk or an
optical disk cartridge to be used on other optical disk drives.
Disk damage: Clean a cartridge in a dust-free environment.
Fujitsu recommends wearing disposable gloves during cleaning so
that no fingerprints are left on a disk.
Disk damage: Do not press hard or apply excessive shock to an
optical disk cartridge case while setting it in the setting case.
Eye inflammation: If the cleaning solution gets into your eyes,
immediately wash the solution away with water.
5-5
5-9
5-10
5-10
5-11
5-11
Maintenance and Repair
Data loss: For a repair request, you normally do not need to
include any optical disk cartridge with an optical disk drive.
However, you do need to include a cartridge if errors keep
occurring with a specific cartridge. In such a case, be sure to save
data stored in the cartridge before sending it in. Fujitsu shall bear
no responsibility for any data lost during service or repair.
6-3