Filter
Top Products
Index
IN-4 C156-E227-01EN
read cache 4-38
READ CAPACITY command 4-64
READ CAPACITY data (PMI=0) 4-64
READ CAPACITY data (PMI=1, MO
media, FROM media) 4-64
READ CAPACITY data (PMI=1, PROM
media) 4-65
READ command 4-63,
READ DEFECT DATA command 4-66
READ FORMAT CAPACITIES command
4-65
READ FORMAT CAPACITIES data format
4-65
READ LONG command 4-68
read-write error recovery page 4-51
RECEIVE DIAGNOSTIC RESULTS
command 4-68
recommended optical disk cartridge 2-8
reliability 1-3, 2-7
removable block access capabilities page
4-56
removing optical disk cartridge 5-4
representative model name 2-1
REQUEST SENSE command 4-69
request sense data 4-69
requirement
environment 2-5
power 2-5
reset recovery 4-32
reset response 4-36
response to Get Status when device is
specified 4-10
response to Get Status when end point is
specified 4-11
response to Get Status when interface is
specified 4-11
response to Prevent/Allow/Eject 4-62
revision label 6-3
revision number 6-3
revision number indication 6-4
S
safety standard 1-4
SEEK command 4-74
SEND DIAGNOSTIC command 4-73
sense key 4-70
separte optical section 1-8
service area 3-12,
service life 2-7, 6-2
service system and repair 6-2
Set Address 4-12
Set Configuration 4-13
Set Feature 4-14
Set Interface 4-15
setting optical disk cartridge into setting case
5-10
setup data format 4-3
setup data format for Clear Feature 4-7
setup data format for Get Configuration 4-8
setup data format for Get Descriptor 4-8
setup data format for Get Interface 4-9
setup data format for Get Status 4-10
setup data format for Set Address 4-12
setup data format for Set Configuration
4-13
setup data format for Set Feature 4-14
setup data format for Set Interface 4-15
shutter 2-10
shutter open 2-9
specification 2-1
MCL3064UA 2-3
MCM3064UB, MCM3130UB 2-2
specification of disk 2-11
specification of drive 2-2
specification of optical disk cartridge 2-8
specification of optical disk drive 2-1
spindle motor 1-7
standard request 4-3, 4-6
standard request code 4-5
standard USB device request (USB1.1) 4-1
standby mode 4-41
standby timer 4-41
START/STOP/EJECT processing 4-75
START/STOP UNIT command 4-74
storage 3-20
storing cartridge 5-8
String 4-23
String descriptor (LANGID and
Manufacture) 4-23
String descriptor (Product) 4-24
String descriptor (Serial Number) 4-26
supported request 4-1
surface temperature measurement point 3-2
Suspended 4-3
SYNCHRONIZE CACHE command 4-75
system ground (handling of SG and FG)
3-13
T
temperature at measuring point (reference)
3-3
temperature measurement point 3-1
temperature requirement 3-2
temperature requirement at measurement
point 3-2
temperature rise 3-3
test program 6-2
TEST UNIT READY command 4-75