Filter
Top Products
9
The following illustrates important cautions described in this manual.
Avoid getting a sleeve, necktie, or hair caught up in any scanner mechanism when scanning
as this may cause injuries.
Do not use any aerosol sprays or alcohol based sprays to clean the scanner.
Dust blown up by strong air from the spray may enter the inside of the scanner. This may
cause the scanner to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and dirt from the outside
of the scanner may cause a fire.
CAUTION
Install the scanner on a flat, lever surface. Make sure none of the scanner parts protrudes
outside the desktop.
Do not install the scanner on unstable surfaces. Install the scanner on a level surface that is
free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner and other
devices.
Install the scanner away from strong magnetic fields and other sources of electronic noise.
Also, protect the scanner from static electricity as this might cause the scanner to malfunction.
When handling the paper or Carrier Sheet, be careful not to cut your fingers by the paper or
Carrier Sheet.
Do not use the device immediately after moving it from a cold place into a warm room. This
may cause condensation, which might lead to scanning errors. Let the device dry about one
or two hours before you use it.
When carrying the scanner outside while it is raining or snowing, pay close attention so the
scanner does not get wet or moistured.
Do not block the ventilation ports. Blocking the ventilation ports generates heat inside of
scanner, which may results in fire or scanner failure.