Filter
Top Products
Working with the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the mains adapter cable to the DC
jack (DC IN) of the Port Replicator (1).
► Connect the power cable to the
mains adapter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for outpu t. This profile will be loaded, as
soon as the notebook is connected to a Port Replicator of th e same type.
Switching on the notebook via the port replicator
► Press the ON/OFF
switch on the port
replicator to sw
itch the notebook on.
The pow er-on indica tor of the Port
Replicator lights up.
Switching
off notebook via Port Replicator
► Close all applications an d shut down your operating system (please refer
to the manual for the operating system).
If the notebook cannot be shut down properly, press the ON/OFF button
on the Port Replicator for approx. four seconds. The notebook will switch
off. Any unsaved data may however be lost.
74 Fujitsu Technology Solutions