Filter
Top Products
POWER SUPPLY INFORMATION
(NON INTERNAL POWER SUPPLY MODELS)
Panasonic recommends using a Lind Auto Adapter (Lind part number PA1580-2961) to power the
docking station. It can be ordered from Gamber-Johnson (part number 14103) or directly from Lind
Electronics, Minneapolis, Minnesota (952-927-6303).
Installation of the Power Jack:
Remove the #8-32 screw and the Power Cable Cover on the bottom of the dock (Figure 4). Attach the
Power Cable Pull Strap (located in the hardware bag) to the power jack as shown (Figure 5). Plug the
power jack into the input jack, located on the port replicator circuit board inside the docking station,
and tuck the pull strap into the docking station as shown (Figure 6). Replace the Power Cable Cover
to secure the power jack (Figure 7).
Figure 5
Figure 6
Insert power jack into mating jack
on port replicator board and tuck
the pull strap into the electrical box.
Power Cable Pull Strap
Pg 6
Figure 4
Figure 7
Remove #8-32unc screw
and Power Cable Cover
Replace Power Cable Cover
to hold the power jack in place.