Filter
Top Products
Magnum DS50 / DS60s Dual Speed Hubs Installation and User Guide (06/02)
five shared 10/100Mb RJ-45 ports and one “10/100Mb switched RJ-45 port. There is an up-link
(UPLINK) switch for Port 1. There is a manual switch “FF-A” underneath the switched port #6
that controls and provides “full-fixed” and “Auto-negotiation” capability to the port.
2.2.4 Port #6: Switched 10/100 Mb/s Port for DS60C only
For Magnum DS60C
Dual-speed Hub plus has Port 6 as a
switched port located on the right
front panel. Because of its dual
speed and auto negotiation
capability, it operates either as a
10BASE-T port or as a 100BASE-
TX port. The speed may depend
upon the attached unit’s speed. See section 4.3 for more details about the 10 or 100 switch.
FF-A
Manual Switch
Figure 2.2.3: Port 6: Switched 10 or100Mb Port
Link LED
RX LED
6
RX
FDX
100
LK
FF-A
100 LED
FDX
This switched port offers great flexibility in connecting the DS60C . . . as an
additional 10/100Mb segment . . . to an existing 10 or 100Mb network. Because this port is
segmented from the other DS60C ports, it provides a separate collision domain. Accordingly,
the DS60C can be used as plug-and-play in practically any 10Mb or 100Mb network domain.
The Magnum DS60C has power (PWR) and collision (COL) LED’s and 10 and 100
LED’s for the unit. It also has link (LINK) and receive (RX) activity LED’s for each of the
five shared ports and for Port 6. The port #6 has Full-duplex (FDX) and speed (100) LED’s too.
Rubber feet on the bottom provide a sturdy grip and clearance for the exhaust of the cooling
fan.
The internal power supply is an auto ranging AC power input of 115-230 vac, 50/60
Hz. The recessed male IEC power connector is located at the right-rear. Two mounting
brackets for optional wall mounting are supplied with each unit. An optional “edge- stand” is
available (See “Spare Parts Price List”) and is used for floor-mounting on carpeted surfaces.
2.2.5 Magnum DS50 Dual-speed Hubs Chassis
The Magnum DS50 chassis houses one main board for the five dual-speed repeater
ports. It has an internal power supply and a small cooling fan in the bottom. The front side of
chassis consists of five shared 10/100Mb RJ-45 ports. There is an up-link (UPLINK) switch
next to Port # 1, which it controls.
9
www GarrettCom com
..