Filter
Top Products
GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 17
Section 7: Display Control Panel
Stand-by
Pressing STAND-BY will cause the
laminator to go into the AUTO-OFF mode.
The laminator will automatically go into this
mode after sitting idle for an extended
amount of time. When in AUTO-OFF mode
the laminator will no longer continue to heat
the main rollers to save power.
Stand-by
Pressing MEMORY will cause the current
speed and heat settings to be recorded in the
JOB memory location shown on the display.
Jobs
Pressing the up or down arrows will cause
the unit to cycle through stored jobs. Up to
9 separate jobs can be stored. To save a job,
select one of the nine jobs to overwrite.
Then change the heat and speed settings as
required for your application. Once
selected, press the memory button once.
Measure
Press and hold the MEASURE key to
display the current roller temperature.
Cooling
When the COOLING button is pressed the
cooling fans will turn on or off. The
COOLING button will illuminate green
when the fans are on. The fans blow fresh
air on the film web in between the heat and
pull rollers.
Run
When the RUN is pressed the rollers will
begin turning. However, pressing run will
not cause the rollers to turn when any of the
following are true: the Emergency Stop is
engaged, Safety Shield is raised or removed
and/or the feed table is removed.