Filter
Top Products
9
ೋ
Troubleshooting Guide
SYMPTOM
• POWERindicator does not illuminate when
Main power switch is in the ‘ON’ ( )
position.
• Laminated items are wrinkled.
• Laminated items are wavy.
• Laminated items are cloudy.
• Unsatisfactory adhesion to media.
CORRECTIVE ACTION
Push standby switch on control panel.
Insert plug into appropriate receptacle.
Replace fuse.
Close lever completely.
Reduce temperature by turning temperature control
counter-clockwise.
Increase temperature by turning temperature control
clockwise.
Wait for the ready light to illuminate.
Increase temperature by turning temperature control
clockwise.
Ready light must be illuminated.
The composition or finish of the media may not be
compatible with the thermal lamination process.
POSSIBLE CAUSE
Standby switch on control panel is not
activated.
Laminator is not connected to electrical
supply.
Fuse is blown.
Tension on top or bottom supply roll is too
loose.Film holder lever is not closed.
Excessive heat.
Insufficient heat.
Ready light is not illuminated.
Insufficient heat.
Laminated item may not be suitable for
thermal lamination.
Warranty
Operation of this machine is guaranteed for two years from date of
purchase,subject to normal use.Within the guarantee period,GBC will at
its own discretion either repair or replace the defective machine free of
charge.Defects due to misuse or use for inappropriate purposes are not
covered under the guarantee.Proof of date of purchase will be required.
Repairs or alterations made by persons not authorized by GBC will
invalidate the guarantee.It is our aim to ensure that our products perform
to the specifications stated.This guarantee does not affect the legal rights
which consumers have under applicable national legislation governing the
sale of goods.
Register this product online at www.gbc.com