Filter
Top Products
5-8
5. Home Screen
Selection of a new Die Set will prompt the Die Set screen to come up. This
screen will prompt you to remove the proper Punch Pin numbers for the paper
size you are running. In the example shown, there are two possible pin configu-
rations with this Die Set and Paper combination. The Die Set itself features a
handy reference label to identify the Pin numbers. The Quantum will automati-
cally center the Die Set to the paper size selected if you press buttons 2 or 4. By
pressing buttons 1 or 2, the Quantum will perform all required adjustments (bind
edge, side edge & center the die).You can manually fine-tune the hole centering
by pressing the right-left arrows at this screen.
Note that the pins indicated on the display are the pins that should remain in the
Die Set, i.e. pull the pins to the left and right of the range indicated.
Note: in the screen above, the graphic should sow pins “4 - 23 and 5 – 23” not “1 – 23 and 5 – 23”.
123
456
789
0OK
ESCAPE SAVE ACCEPT
USE ARROWS TO
CHANGE
GO TO NEXT
SETTING
NO CHANGE
GO BACK
DATA OK
STORE
EDITOR
ESCAPE
ACCEPT
SAVE
PB .141
11"
8.5"
1
“GO JOB” SCREEN