Filter
Top Products
GEI-100305 Auxiliary Drive to ISBus Interface Board IS200ADII
•
••
•
1
7
Installation Procedures
To prevent electric shock, turn off power to the drive,
then test to verify that no power exists in the drive
before touching it or any connected circuits.
To prevent equipment damage, do not remove, insert, or
adjust board connections while power is applied to the
equipment.
Ø
ØØ
Ø To install a new ADII Board in a drive
1. Make sure that the drive in which the board is to be installed has been
deenergized. (Refer to the appropriate User's Guide for complete de-energizing
procedures and follow all local practices of lock out/tag out.)
2. Open the drive’s cabinet door, and using equipment designed for high voltages,
test any electrical circuits before touching them to ensure that power is off.
3. Install the ADII board in the drive as follows:
a. Release the two board carrier retainers by pulling them forward.
b. Lift up and rotate the front board carrier out and down until it is resting on
its stops.
c. Place the board in position on the four tabs (on left side) of the back of this
board carrier and press it firmly into position on these tabs.
4. Install the LNPL ribbon cable into the LNPL connector on the ADII board and
the LNPL connector on the LDCC board.
5. Install the COM1 wire onto the E1 (COM1) stab-on terminal on the ADII board
and the E1 (COM1) terminal on the LDCC board.
6. Install the CHASSIS wire onto the E2 stab-on terminal on the ADII board and
secure the other end to an accessible screw on the drive chassis.
The chassis wire must be securely mounted to the drive’s
chassis to shunt the ISBus shield to ground.
Care must be taken to keep the chassis wire tight to the ADII
board and away from the power supply board at all times. Use
a wire tie down strap connected to the bottom of the board
carrier to keep it away from the power supply board.
7. Plug the 2PL cable connector into the 2PL receptacle on the ADII board.
8. Install an ISBus cable into the RX/IN RJ45 jack (P3) on the ADII board and the
TX/OUT jack (P2) of the previous device on the ISBus.
9. Install an ISBus cable into the TX/OUT RJ45 jack (P2) on the ADII board and
the RX/IN jack (P3) of the next device on the ISBus.