Filter
Top Products
CONNECTING THE 4X1 DISPLAYPORT SWITCHER
11
How to Connect the 4x1 DisplayPort Switcher
1 Connect up to four (4) DisplayPort source devices to the DisplayPort inputs
on the back panel of the Switcher using DisplayPort cables.
2 Connect a DisplayPort-supported display to the DisplayPort output on the
back panel of the Switcher.
a OPTIONAL: To use the RS-232 communication feature, connect an
RS-232 cable between the Switcher and RS-232 host controller.
b OPTIONAL: To communicate with the Switcher using Telnet, connect an
Ethernet cable from the Ethernet jack on the back of the Switcher to the
network. See page 24 for more information on using the Telnet feature.
c OPTIONAL: To extend the range of the IR control, connect an IR
Extender (Gefen part no. EXT-RMT-EXTIR) to the back of the Switcher.
3 Connect the included 5V locking power supply to the power receptacle on
the 4x1 DisplayPort Switcher
4 Connect the opposite end of the power supply to an open wall socket power
source.
Wiring Diagram for the 4x1 DisplayPort Switcher
RS-232 Controller
EXT-DP-441
Computer
Computer
Computer
Computer
DisplayPort Display
DISPLAYPORT CABLE
RS-232 CABLE
ETHERNET
IR
DisplayPort Switcher
Router
IR Extender
ATTENTION: This product should always be connected to a
grounded electrical socket.