Filter
Top Products
v
HD KVM over IP
• The HD KVM over IP is compatible with the DVI KVM over IP and the VGA KVM over
IP, which allows these products to be connected within a single system. Note that
HDCP content may not pass-through when using these products in tandem.
• CAT-5 or CAT-6 cables should not exceed 330 feet (100 meters) between the
Sender / Receiver unit and the network.
• By default, all Sender and Receiver units are set to channel 0.
• This product supports HDCP when using and HDKVM-LAN Sender with an HDKVM-
LAN Receiver.
• This product does not support dual link resolutions.
• By default, the source device will use the EDID from the display (or other sink device)
which is connected the Receiver unit. See EDID Management for more information.
• If terminating network cables in the eld, please adhere to the TIA/EIA568B
specication. See the Network Cable Diagram for details.
The following table (continued on next page) details the IP and IP port use of the HD KVM
over IP. Each “X” in the table, below, represents that no specied IP port is required.
Type
Sender A D Receiver
Description
Link Manager
TCP
6751 A X
msg_channel, ast_heartbeat
UDP / MC
X D 3246
ast_heartbeat multicast port
Use the “multicast stream” multicast IP
UDP / MC
3333 D 3334
3334 A 3333
“Name Service”
Use 225.1.0.0 multicast IP
3333 listen for query; 3334 for reply
Type
Sender A D Receiver
Description
Operating Notes
IMPORTANT: The use of a Gigabit switch with 8K “jumbo frame”
capability is required when connecting the HD KVM over IP to a
network.