Filter
Top Products
Software Installation
If you intend to use the USB interface, you must start by installing the
Intermec USB printer driver, which is included on the CD-ROM that
comes with the printer.
If you run your EasyCoder PC4 from a PC under Windows 98/Me, or
Windows NT 4.0/W2000/XP, you may want to install the Intermec
InterDriver and the Intermec LabelShop START found on the CD-
ROM that comes with the printer.
If you use any other operating system than Windows, you will need
to use the ESim protocol described in the Intermec ESim v6.XX, Pro-
grammer’s Reference Manual. (Intermec ESim also supports Windows.)
Updates and installation instructions are available at the Intermec home
page http://www.intermec.com.
Note: ere are different firmware for the 203.2 dpi (8 dots/
mm) and the 300 dpi (11.81 dots/mm) versions.