Filter
Top Products
6 Similarly, install an empty core in the rewind (front) position.
7 Route the end of the transfer ribbon forward under the printhead and
up in front of it. Using the tape fitted at the front of the ribbon leader,
affix the leader to the top of the rewind core. Be careful to center-align
the leader with the core.
8 Wind the green wheel on the right side of the rewind hub clockwise
to wind up the leader onto the rewind core until the black ink-coated
ribbon becomes visible. Remove any slack.
9 If so required, also load a fresh supply of receiving face material, for
example labels, according to instructions earlier in this chapter.
10 Close the print carriage by pressing it firmly down simultaneously on
both sides. A loud click indicates locked position.
11 Firmly close the printer's top cover.
12 Tap the Feed key until the indicator lamp becomes green.
Removing a Partially Used Ribbon
When switching between direct thermal and thermal transfer printing,
or when switching between different types of transfer ribbon, a partially
used transfer ribbon can be removed and saved for later use.
1 Open the printer's top cover by pressing the release buttons on both
sides and folding the cover upwards/rearwards.
2 Press the green release tabs at the bottom of the top cover on both
sides of the printhead and fold down the print carriage halfway (45°
angle) while keeping the top cover fully opened.
3 Using a pair of scissors, cut the transfer ribbon just below the rewind
roll.
4 Rewind the unused ribbon onto the supply spool. Remove the roll by
pushing it to the left until the right end disengages and then lifting
the roll up. Fasten the loose end with a piece of tape or label to pre-
vent the roll from unwrapping.
5 Remove the rewind roll by pushing to the left and lifting up. Unwind
the used ribbon into a waste basket or similar until you can dispose
of it according to local environmental regulations. Keep the core! You
will need it next time you load a ribbon.