Genicom PC4 Manual

A SERVICE OF

next previous

 



Normal position

Firmware down-

load position

Instructions

Using a PC

1 Install the Intermec EasyCoder PC4 Conﬁg Tool in your PC.

2 Run the PC4Conf.exe program.

3 Set up the parameters for the ﬁrmware download. Use the on-line

help for instructions.

4 Start the Firmware download wizard and follow the instructions on

the screen.

Using a Memory Cartridge

1 Switch oﬀ the printer.

2 Move the switch on the side of the cartridge to the upper position.

3 Insert the cartridge.

4 Switch on the printer. e indicator lamp will start blinking during

the upgrading. Wait until the blinking stops, which takes about 40

seconds.

5 Switch oﬀ the printer and remove the memory cartridge. Put back the

cover over the memory cartridge slot.

If the cartridge is removed at an angle, the connector pins

may be bent.