Filter
Top Products
16
Uncheck the Allow Association to Mixed Cells check box if the access point to which the
client adapter is to associate (or the VLAN to which the client will be assigned) does not
have WEP set to Optional. This is the default setting.
None – no security is set. (Default setting)
Select the type of security encryption (WPA/WPA2, WPA/WPA2-Passphrase, WEP or
RADIUS 802.1X) from the radio buttons, and click Configure. Depending on the security
selected, the following Configure Security Screens will appear.
Configure Pre Shared Key (WEP) Security
To use WEP, select if you want Hex or ASCII method, enter a pre-shared key, select
64-bits, 128-bits, or 152-bits from the drop down box and click OK.
Note: ASCII text WEP keys are not supported on GIGABYTE Routers, you must choose the Hexadecimal
(0-9,A-F) option if you are connecting with these Access Points.
Figure 3-6. WEP key configuration
WPA/WPA2-Passphrase
When you select WPA/WPA2, the target 802.11 device must also be WPA/WPA2 enabled
in order to communicate with each other. Obtain the WPA/WPA2 Passphrase for the
access point from your system administrator and inter it in the WPA/WPA2 Passphrase
field.
• WPA/WPA2 Passphrase must contain 8 to 63 ASCII text characters or 64
hexadecimal characters.
• Your client adapter's WPA/WPA2 Passphrase must match the Passphrase used
by the access point with which you are planning to communicate.
Click OK to save your changes and to return to the Profile Management window.