Filter
Top Products
Februaray-2006 Page 16 / 42 MasterVoIP VoIP to GSM Gateway
The following table describes the various configurations to be performed:
End User
Password
This contains the password to access the Web Configuration Menu. This field is case sensitive
with max. 25 characters
IP Address There are 2 modes under which the IP phone can operate:
- If DHCP mode is enabled, then all the field values for the Static IP mode are
not used (even though they are still saved in the Flash memory) and the IP
phone will acquire its IP address from the first DHCP server it discovers on the
LAN it attaches to.
To use PPPoE feature please set the PPPoE account settings if the HT-286 is connected directly to
a DSL modem. The HT-286 will attempt to establish a PPPoE session if any of the PPPoE fields is
set. In this mode, the WAN side web access is disabled and TFTP upgrade for firmware is not
feasible and HTTP upgrade is the only available solution.
- If Static IP mode is selected, then the IP address, Subnet Mask, Default
Router IP address, DNS Server 1 (primary), DNS Server 2 (secondary) fields will need to be
configured. These fields are reset to zero by default.
Time Zone This parameter controls how date/time will be displayed according to the specified time zone.
Daylight Savings Time This parameter controls whether the displayed time will be daylight savings time or not. If set to
“Yes”, then the displayed time will be 1 hour ahead of normal time.
In addition to the Basic Settings configuration page, the end user also has access to the device Status page.
The following is a screen shot of the device Status page.