Filter
Top Products
lines printed on the holder to line up the image. Handle the clear plastic layer only
by the edges to avoid ngerprints. Curl the plastic layer back and slip the front edge
into Flextight’s foil holder.
9. Lay the top layer of the holder down at over the original.
• For the reective holder, note the four metal pegs (the top two are shown as
A and
C in the gure below); make sure that the clear plastic sheet is pressed all the way
down over all four pegs. Note also the two curved tabs at the top of the holder (B in
the gure below); the clear sheet must slip under each of these tabs, as shown.
10. Go to your computer and follow the directions given in the FlexColor software
manual to take a preview, make settings, and take the nal scan. Alternatively you
can press the scan button on the light table. This will initiate a 3F scan according to
your 3F settings.
Resolutions
True Resolutions
e table below shows the max. resolutions (in ppi) available with each of the original
holders when scanning in True Resolutions mode.
Original Max. resolution (ppi) at full scanning width.
35 mm Portrait 8000 (Flextight X5) 6300 (Flextight X1)
35 mm Landscape 5000
45 x 60 mm Portrait 4000
60 x 60 - 60 x 70 mm 3200
4” x 5” Portrait 2040
A4 Portrait 960
Table 1: True Resolutions
! " #
10