Filter
Top Products
9.
If it is necessary to replace the optical drive connector board:
a. Remove the Philllips PM2.0×2.82 screw (1) that secures the connector board to the
optical drive.
b. Remove the connector board (2).
Reverse this procedure to install the optical drive cable.
Power connector cable
Description Spare part number
Power connector cable 654170-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery cover and battery (see
Battery on page 36).
5. Remove the memory module/wireless module compartment cover (see
WLAN module
on page 41).
6. Remove the top cover (see
Top cover on page 49).
60 Chapter 4 Removal and replacement procedures