Filter
Top Products
2-27
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
VLAN Port Config
You can configure VLAN behavior for specific interfaces, including the default
VLAN identifier (PVID) and accepted frame types. This page allows you to
change the VLAN membership and behavior of individual ports. Each row of
the table corresponds to one port or trunk; trunked ports cannot be configured
individually.
Field Attributes
VLAN Per Port Configuration
• Port/Trunk – The port number or the ID of a trunk.
• VLAN Aware Enabled – VLAN aware ports are able to use VLAN
tagged frames to determine the destination of the frame. Click to
enable or disable VLAN awareness mode for this port.
(Default: Enabled)
• Ingress Filtering Enabled – If enabled, incoming frames for VLANs
which do not include this ingress port in their member set will be
discarded. (Default: Disabled)
• Packet Type – Users can set the interface to accept all frame types,
or only tagged frames.
If the Packet Type is set to “All,” the port can accept incoming tagged
and untagged packets. Untagged packets will be associated with the
VLAN identified by the PVID. Tagged packets will be dropped unless
the port is a member of the VLAN identified by the VLAN tag in the
packet.
If the Packet Type is set to “Tagged,” the port will only send tagged
packets. (Default: All)
• PVID – From a drop down menu, choose the VLAN ID that will be
assigned to untagged frames received on this port. You cannot choose
“None” for the VLAN ID unless the packet type is set to “Tagged Only.”
Choosing “None” will not assign any VLAN ID to untagged frames
received on this port. It is not possible to remove a port from VLAN
1 unless its PVID has been changed to something other than 1. The
PVID has no effect on ports that have Packet Type set to Tagged.
(Default: 1)