Filter
Top Products
1 Ensure that the plotter is switched off
and that the power cord and interface
cable(s) are not connected to it.
2 At the back of the plotter, ensure that
the two small wire clamps of the parallel
port are positioned vertically.
No interface
cables connected.
Power inlet: cord
not connected
3 Remove the screws that attach the
electronicsĆenclosure cover to the
electronics enclosure.
zH H haH cH
zH H haH H cH
4 Gently lift open the electronicsĆenclosure
cover to an angle of 45
d
.
Torx-20
or
Flat
6Ć5 Removal and ReplacementC3187Ć90000
Repair Procedures
Removing the ElectronicsĆEnclosure Cover