Filter
Top Products
2 Connecting to a Netware 4.11 Server
Windows for Workgroups
6 Remove the 3COM cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
If you are using a Vectra VL8, go straight to step 7.
If you are using a VL7 or VE7/VE8, finish the installation by using the
instructions below.
a Execute INSTSTALL.EXE.
b Specify the settings as listed below:
• C:\NWCLIENT
•Yes
•Yes
• C:\WINDOWS
•No
• 3Com Fast Etherlink/Etherlink III Bus Master for VE7/VE8, (or
3COM Etherlink III Parallel Tasking Family for VL7, then highlight
option 6 and then go to step e below).
c Under the heading "Select the driver for your network board", insert
the 3Com 3C590 drivers disk and set the path to "A:\NETWARE\
CLIENT." (If you have an HP preloaded HDD, set path to "C:\
Masters\LanDrv\3C509\NWCLIENT\)
d Press "Enter" to continue the installation.
e When prompted, insert the corresponding disks to complete file
transfer and driver installation.
f When the install utility is finished, press <CRTL><ALT><DEL> to
restart the machine.
g After Windows loads, open the "NETWORK" folder, double-click the
"NETWORK SETUP" icon.
h Select "Networks", and verify that "Novell Netware (Workstation Shell
4.0 and above)" is listed under "Install Windows support for the follow-
ing network only:" and click on "OK."
7 Execute INST_DOS.EXE and enter yes to accept the agreement.
8 Accept the default products by pressing enter, and then press “F10” to
continue.
9 Select 16-bit LAN Drivers and hit the enter key.