Filter
Top Products
3. Lift the display assembly (4) straight up and remove it from the base enclosure.
4. If it is necessary to replace the display bezel, display enclosure, or display hinges, remove the
four Mylar screw covers (1) and the four slotted T8 M2.5×5.0 screws (2) that secure the display
bezel to the display assembly. The screw covers are available in the Rubber Kit, spare part
number 599564-001.
5. If it is necessary to replace the bezel, remove it as follows:
a. Flex the top of the bezel from the inside edge until it disengages from the display back
cover (1).
b. Flex the bottom of the bezel from the inside edge until it disengages from the display back
cover (2).
Component replacement procedures 63