HP (Hewlett-Packard) 480-0005-00-15 Switch User Manual


 
1-2 P/N 480-0005-00-15
Chapter 1: Overview
What is Tenor CMS?
The Tenor Carrier MultiPath Switch (CMS) is a high-density VoIP (Voice over Internet Protocol) H.323
switch that digitizes voice and fax data and transmits it over the IP network. Tenor CMS is available in three
configurations: CMS (14 slot), CMS960 (8 slot), and CMS240 (2 slot); each is a slotted, scalable system that
intelligently switches calls over both the IP network and the PSTN in order to ensure high quality voice. Tenor
CMS functions as a gateway, gatekeeper, and a border element. The gateway converts circuit switched calls to
VoIP calls, the gatekeeper performs IP call routing functions, and the border element distributes the call rout-
ing directories throughout the network.
Each Tenor CMS is available with either AC or DC input power.
NOTE: Figure 1-1 illustrates Tenor units with AC power.
Figure 1-1 Tenor CMS VoIP Switch
The slotted system architecture boasts peripheral cards, which interface to various Wide Area Networks
(WANs). Tenor CMS connects to T1/E1 lines operating in either a trunk circuit or line circuit configuration.
The individual spans within the Tenor CMS may connect to either the PSTN or to T1/E1 termination equip-
ment on the user premises (i.e., PBX).
The high performance System Controller/CPU card provides up to four 10/100BaseT connections and one
RS-232 serial port connection; this card is an intelligent call routing engine which regulates system resources
and configuration while coordinating all voice traffic activity in the unit. The DS1, T1, and E1 cards provide
connections. The DS1 card also provides DSP processing (DSP is a signal processing resource; it performs
CMS (14 Slot)
CMS960 (8 Slot)
A.C. Power Supply
Power
QUIN TUM
TECHNOLOGIES, IN C.
TM
TECHNOLOGIES, INC.
QUIN TUM
TM
Hot Swap
DS1
Span
Statu s
4
8
3
7
26
15
10/100
Ethernet
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
Sta tus
PC I
TECHNOLOGIES, INC.
QUINTUM
TM
CPU
4
8
3
7
26
15
Alarm
CPU
2
St at us
PCI
Reset
10/100
Ethernet
Link TX/RX
Hot Swap
CMS240 (2 Slot)
0
1
Reset +3.3V +5V +12 V -12V
Q
UINTUM
T
ECHNOLOGIE S, INC.
TM
Q
UINTUM
T
ECHNOLOGIE S, INC.
TM TM
Fau l t Fau l t
TM
Ground
Strap
Statu sAlarm
CPU PCI
Reset
10/100
Ethernet
Link TX/RX
1
2
3
4
Q
UINTUM
TM
TECHNOLOGIES,
INC.
Hot Swap
CPU
Hot Swap
DS1
StatusAlarm
12
PCI
CPU
BankDSP
1
2
TX/RXLink
1
2
3
4
5
6
7
8
10/100
Ethernet
Span
Status
TECHNOLOGIES,
INC.
Q
UINTUM
TM
A.C. Power Supply
Power
QUINTUM
TECHNOLOGIES, INC.
TM
QUINTUM
TECHNOLOGIES, INC.
TM
TECHNOLOGIES, INC.
QUINTUM
TM
Hot Swap
DS1
Span
Stat us
4
8
3
7
26
15
10/100
Eth ernet
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
Sta tus
PC I
A.C. Power Supply
Power
QUINTUM
TECHNOLOGIES, INC.
TM
TECHNOLOGIES , INC.
QUINTUM
TM
CPU
4
8
3
7
26
15
Alarm
CPU
2
Sta tus
PC I
Reset
10/100
Eth ernet
Link TX/RX
Hot Swap
A.C. Power Supply
Power
QUINTUM
TECHNOLOGIES, INC.
TM
TECHNOLOGIES , INC.
QUINTUM
TM
Hot Swap
DS1
Span
Stat us
4
8
3
7
26
15
10/100
Et hern et
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
Sta t us
PCI
TECHNOLOGIES, INC.
QUINTUM
TM
Hot Swap
DS1
Span
Stat us
4
8
3
7
26
15
10/100
Ethernet
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
St at us
PCI
TECHNOLOGIES , INC.
QUINTUM
TM
Hot Swap
DS1
Span
Stat us
4
8
3
7
26
15
10/100
Eth ernet
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
Sta tus
PC I