Filter
Top Products
P/N 480-0005-00-15 3-9
Chapter 3: Installation
Connect to PC Console (with System Controller)
You will need to connect the Tenor CMS chassis to your workstation’s serial port via RS-232 connection.
(This connection will be used when you assign an IP address to the chassis. The instructions below assume
you are connecting to a PC).
NOTE: For illustration purposes, the CMS (14 Slot) AC unit is shown
Figure 3-6 Connect to PC Com
NOTE: You must use a null modem cable with a DB-9 male connector (see section Chapter 2: Hardware
Components for pinouts) to connect the System Controller card to a PC as follows:
1. Insert the male end of the DB-9 cable (yellow cable if provided by Quintum) into the System Controller
card’s port labeled Console. (See Chapter 2: Hardware Components for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for
more information about this port).
DB-9
Multi-Path Voice Gat eway
TM
TECHNOLOGIES, INC.
QUINTUM
Another Fine Product From
0
1
Reset +3.3V +5V +12V -12V
QUINTUM
T
ECHNOLOGIES, INC.
Console
ABT
BFL CPU
CPCI PCI
.295
.531
TM
QUINTUM
T
ECHNOLOGI ES, IN C.
QUINTUM
T
ECHNOLOGIES, INC.
TM TM
System
Controller
RST
Fault Fault
10/100
Ethernet
Tenor CMS
QUINTUM
TECHNOLOGIES, INC.
© Copyright 2001 Quintum Technologies Inc.
TM
TM
Ground
Strap
TM
Hot Swap
DS1
Status
Alarm
12
PCICPU
BankDSP
1
2
TX/RXLink
1
2
3
4
5
6
7
8
10/100
Ethernet
Span
Status
TECHNOLOGIES, INC.
QUINTUM
TM
Tenor CMS
QUINTUM
TECHNOLOGIES, INC.
© Copyright 2001 Quintum Techn ologies Inc.
Chassis Front
Console
ABT
BFLCPU
CPCIPCI
.295
.531
TM
RST
10/100
Ethernet