Filter
Top Products
Configuring IP Addressing
IP Configuration
A Switch 5300XL with
IP Addressing and
VLANs Configured
Figure 7-3. Example of Show IP Listing with Non-Default IP Addressing Configured
Configure an IP Address and Subnet Mask. The following command
includes both the primary IP address and the subnet mask. You must either
include the ID of the VLAN for which you are configuring IP addressing or go
to the context configuration level for that VLAN. (If you are not using VLANs
on the switch—that is, if the only VLAN is the default VLAN—then the VLAN
ID is always “1”.)
Not e The default IP address setting for the DEFAULT_VLAN is DHCP/Bootp. On
additional VLANs you create, the default IP address setting is Disabled.
Syntax: [ no ] vlan < vlan-id > ip address <ip-address/mask-length>
or
[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >
or
vlan < vlan-id > ip address dhcp-bootp
This example configures IP addressing on the default VLAN with the subnet
mask specified in mask bits.
HPswitch
(config)# vlan 1 ip address 10.28.227.103 255.255.255.0
This example configures the same IP addressing as the preceding example,
but specifies the subnet mask by mask length.
HPswitch(config)# vlan 1 ip address 10.28.227.103/24
This example deletes an IP address configured in VLAN 1.
HPswitch (config) no vlan 1 ip address 10.28.227.103/24
7-8