Filter
Top Products
802.1w Rapid Spanning Tree Protocol (RSTP) 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
Not e Executing spanning-tree alone enables STP. Executing spanning-tree with one
or more of the above “STP Operating Parameters” does not enable STP. It only
configures the STP parameters (regardless of whether STP is actually running
(enabled) on the switch).
Syntax: spanning-tree
priority <0 - 65355>
maximum-age <6 - 40 seconds>
hello-time <1 - 10 seconds>
forward-delay <4 - 30 seconds>
Default: See table 13-3, above.
For example, to configure a maximum-age of 30 seconds and a hello-time of 3
seconds for STP:
HPswitch(config)# spanning-tree maximum-age 30 hello-time
3
Reconfiguring Per-Port STP Operation on the Switch. This command
enables STP (if not already enabled) and configures the following per-port
parameters:
Table 13-4.Per-Port STP Parameters
Name Default Range Function
path-cost Ethernet: 100
1 - 65535 Assigns an individual port cost that the switch uses
10/100Tx:
10
100 Fx: 10
Gigabit: 5
to determine which ports are the forwarding ports.
priority 128 0 - 255 Used by STP to determine the port(s) to use for
forwarding. The port with the lowest number has
the highest priority.
mode norm norm
Specifies whether a port progresses through the
- or -
listening, learning, and forwarding (or blocking)
fast
states (“norm” mode) or transitions directly to the
- or -
forwarding state (“fast” mode).
uplink
• For information on when to use Fast mode, see
“STP Fast Mode” on page 13-26.)
• For information on Uplink mode, see “Fast-
Uplink Spanning Tree Protocol (STP)” on page
13-27
You can also include STP general parameters in this command. See “Recon-
figuring General STP Operation on the Switch” on page 13-24.
13-25