Filter
Top Products
7. Connect to the switch console, enter:
connect interconnect <bay number>
8. Change the password when prompted by the switch.
9. To restore the configuration, you must disable the switch with the CLI, the integrated Web Tools GUI,
or the optional Fabric Manager GUI.
NOTE:
If using the CLI, enter switchDisable at the prompt. Refer to the
Fabri c OS command reference
guide
for additional command information.
10. Continue with the switch configuration. Enter the appropriate information when prompted. Make
sure that the d ata entered matches the settings on the fault y switch.
11 . Install the same Fabric OS version as the faulty switch using the CLI command firmwareDownload,
the integrated Web Tools GUI, or the optional Fabric Manager GUI.
12. Verify that the appropriate licenses are installed on the replacement switch.
13 . Save the switch configuration file after making your edits; enter:
configupload
14. Restore the switch configuration from the remote server using the backup con figuration file from step 1.
15 . Enable the switch. Use the CLI command switchenable, the integrated Web Tools GUI or the
optional Fabric Manager GUI.
16 . Connect all external FC cables in the same port locations as before. To connect to the external
switch ports without connectivity to external devices, the external switch port must be disabled prior
to inserting the cable and then re‐enabled after inserting the cable to establish connectivity.
17 . Verify that the switch is joined to the fabric and all connected devices log in to the switc h; enter:
switchshow
18. Save the configuration file.
IMPORTANT:
HP recommends upgrading all switches in the enclosure to the latest available firmware. Check
h
ttp://www.hp.com for updates.
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
39