Filter
Top Products
Small parts
The, I/O door, Rubber feet, and Flash card tray are all replaceable.
To remove the I/O door, open it fully. Flex the door so that the center hinge separates from back case.
Continue to flex until side pins clear holes in back case. To reassemble, just reverse the procedure.
The rubber feet are pressed into the bottom case. To remove, stick a pin into the foot from the side and pull
the foot up. To install a new foot, insert into hole and press firmly.
The Flash card tray assembly (PCMCIA accessory Tray) is removed and installed in the same manner as the
Hard Disk Drive.
27